|
MARK JAWS (1,2,3)
MOUNT JAWS ON CHUCK
BOLT ALL MASTER JAWS THE SAME
DISTANCE FROM THE CENTER OF THE CHUCK
|
 |
|
MARK INSERTS (1,2,3,)
BACK OUT THE CONE POINT LOCK SCREW.
PLACE INSERTS IN CORRESPONDING MASTER
JAW
PLACE INSERT IN MASTER JAW.
(MAKE SURE THE HOOK ON THE INSERT IS
AGAINST THE LOCK PIN IN THE JAW.
TIGHTEN CONE POINT LOCK SCREW.
(USE SHORT HEX KEY WRENCH) |
 |
INSERT PINS IN THE INNER MOST BOLT
COUNTER BORE OF THE MASTER JAWS
(MAKE SURE THE PINS FIT THE COUNTER BORE WELL AND GO DOWN AGAINST
THE TOP OF THE BOLT HEAD)
ONCE INSERTED, THESE PINS SHOULD STICK UP PAST THE MASTER JAW
APPROXIMATELY 5/8" TO 3/4" |
 |
CLAMP ON BORING RING WITH THE INSERTED
PINS.
THIS RING SHOULD BE APPROXIMATELY 1/2" THICK WITH AN I.D. HOLE WITH
ADEQUATE WALL THICKNESS TO ALLOW THE BORE SIZE NEEDED.
WHEN CLAMPED THE JAWS SHOULD BE IN
THE MIDDLE OF THE TOTAL JAW STROKE
|
 |
|
BORE INSERTS APPROXIMATELY .OO5" SMALLER
THAN THE O.D. OF THE WORKPART |
 |
|
REMOVE BORING RING AND BORING PINS.
INSERT WORK PART AND CLAMP. |
 |
